Difference between revisions of "Week 2 Lab"
From Robert-Depot
(New page: === Set up Breadboard === * Power from arduino to breadboard: ** connect positive and negative power buses on proto board ** run power, "5V" and "GND" from arduino to broadboard. ** verif...) |
|||
| Line 1: | Line 1: | ||
=== Set up Breadboard === | === Set up Breadboard === | ||
| − | + | # Power from arduino to breadboard: | |
| − | + | ##connect positive and negative power buses on proto board | |
| − | + | ##run power, "5V" and "GND" from arduino to broadboard. | |
| − | + | ## verify that this worked (with multimeter, or LED test). | |
| − | + | ||
| + | === Simple Digital Out === | ||
| + | # Set up LED on external board, check that it works | ||
| + | # change Blink program (from Sketchbook->Examples->Digital) to run off of one of the external digital pins | ||
| + | # connect the LED to that pin. | ||
| + | |||
| + | === Simple Digital In === | ||
Revision as of 07:58, 7 April 2009
Set up Breadboard
- Power from arduino to breadboard:
- connect positive and negative power buses on proto board
- run power, "5V" and "GND" from arduino to broadboard.
- verify that this worked (with multimeter, or LED test).
Simple Digital Out
- Set up LED on external board, check that it works
- change Blink program (from Sketchbook->Examples->Digital) to run off of one of the external digital pins
- connect the LED to that pin.
