5,710
edits
Changes
GRBL
,no edit summary
*From grbl directory, run <code>$AVRPATH/bin/avrdude -C$AVRPATH/etc/avrdude.conf -pm328p -carduino -P$DEVPATH -D -Uflash:w:$GRBLHEX</code>
**from https://github.com/grbl/grbl/wiki/Flashing-Grbl-to-an-Arduino
== My GRBL defaults ==
<code>
$0=28.175 (x, step/mm)
$1=28.175 (y, step/mm)
$2=250.000 (z, step/mm)
$3=10 (step pulse, usec)
$4=17780.000 (default feed, mm/min)
$5=17780.000 (default seek, mm/min)
$6=56 (step port invert mask, int:00111000)
$7=25 (step idle delay, msec)
$8=500.000 (acceleration, mm/sec^2)
$9=0.050 (junction deviation, mm)
$10=0.100 (arc, mm/segment)
$11=25 (n-arc correction, int)
$12=3 (n-decimals, int)
$13=0 (report inches, bool)
$14=1 (auto start, bool)
$15=0 (invert step enable, bool)
$16=0 (hard limits, bool)
$17=0 (homing cycle, bool)
$18=0 (homing dir invert mask, int:00000000)
$19=25.000 (homing feed, mm/min)
$20=250.000 (homing seek, mm/min)
$21=100 (homing debounce, msec)
$22=1.000 (homing pull-off, mm)
ok
ok
</code>