Week 3 Lab

from Electronic Technologies for Art

Analog Input

• File->Sketchbook->Analog->AnalogInput

Potentiometer

• A_IN can be any pin
• Q: What will the voltage at A_IN be? What are the upper and lower values?
• The important part of this sketch is the line where the microprocessor reads the analog input:

val = analogRead(potPin); // read the value from the sensor

• Q: Looking at the Arduino help for that function (analogRead()), what do you think the value val will be for those highest and lowest voltages at your A_IN pin?
• Q: How can you verify your guess? Try and verify your values, in some way. Anything goes!!!

other loads

photoresistor

• taking the photoresistor from your 147A kit, it has a resistance of ~160k - ~10k (depending on your lighting conditions)
• Q: With the same 10k resistor and setup from the schematic above, replacing the pot with the photoresistor, what range of voltages (and corresponding data values) would you expect to see at your A_IN pin?

Analog Output

LED Dimming

• File->Sketchbook->Examples->Analog->Fading

   analogWrite(ledpin, value);           // sets the value (range from 0 to 255) 

PWM (pulse width modulation)

• lights, fading

<youtube v="62gWVWCyw_w" loop="true"/>

Motor Speed Control

• Basic motor control (DC motors) see week 5

Sound, Tone Generation

• sounds, tone generation