Difference between revisions of "GRBL"
From Robert-Depot
Line 1: | Line 1: | ||
− | == To flash from Terminal == | + | == To flash GRBL to Arduino from Terminal == |
*<code>AVRPATH=/Applications/Arduino.app/Contents/Resources/Java/hardware/tools/avr</code> | *<code>AVRPATH=/Applications/Arduino.app/Contents/Resources/Java/hardware/tools/avr</code> | ||
Line 9: | Line 9: | ||
== GRBL pinout == | == GRBL pinout == | ||
https://github.com/grbl/grbl/wiki/Connecting-Grbl | https://github.com/grbl/grbl/wiki/Connecting-Grbl | ||
+ | |||
+ | == GRBL Settings descriptions == | ||
+ | *https://github.com/grbl/grbl/wiki/Configuring-Grbl-v0.8 | ||
+ | |||
+ | == Gcode Commands == | ||
+ | * https://github.com/grbl/grbl/wiki | ||
== My GRBL defaults == | == My GRBL defaults == |
Revision as of 10:35, 11 March 2013
Contents
To flash GRBL to Arduino from Terminal
AVRPATH=/Applications/Arduino.app/Contents/Resources/Java/hardware/tools/avr
export DEVPATH=/dev/tty.usbmodem1411
export GRBLHEX=grbl.hex
- From grbl directory, run
$AVRPATH/bin/avrdude -C$AVRPATH/etc/avrdude.conf -pm328p -carduino -P$DEVPATH -D -Uflash:w:$GRBLHEX
GRBL pinout
https://github.com/grbl/grbl/wiki/Connecting-Grbl
GRBL Settings descriptions
Gcode Commands
My GRBL defaults
$0=28.175 (x, step/mm) $1=28.175 (y, step/mm) $2=250.000 (z, step/mm) $3=10 (step pulse, usec) $4=17780.000 (default feed, mm/min) $5=17780.000 (default seek, mm/min) $6=56 (step port invert mask, int:00111000) $7=25 (step idle delay, msec) $8=500.000 (acceleration, mm/sec^2) $9=0.050 (junction deviation, mm) $10=0.100 (arc, mm/segment) $11=25 (n-arc correction, int) $12=3 (n-decimals, int) $13=0 (report inches, bool) $14=1 (auto start, bool) $15=0 (invert step enable, bool) $16=0 (hard limits, bool) $17=0 (homing cycle, bool) $18=0 (homing dir invert mask, int:00000000) $19=25.000 (homing feed, mm/min) $20=250.000 (homing seek, mm/min) $21=100 (homing debounce, msec) $22=1.000 (homing pull-off, mm)