Difference between revisions of "GRBL"
From Robert-Depot
(→To flash GRBL to Arduino from Terminal) |
|||
Line 1: | Line 1: | ||
== To flash GRBL to Arduino from Terminal == | == To flash GRBL to Arduino from Terminal == | ||
− | + | *Download GRBL | |
− | *<code>AVRPATH=/Applications/Arduino.app/Contents/Resources/Java/hardware/tools/avr</code> | + | *In the Terminal, |
+ | *<code>export AVRPATH=/Applications/Arduino.app/Contents/Resources/Java/hardware/tools/avr</code> | ||
*<code>export DEVPATH=/dev/tty.usbmodem1411</code> | *<code>export DEVPATH=/dev/tty.usbmodem1411</code> | ||
*<code>export GRBLHEX=grbl.hex</code> | *<code>export GRBLHEX=grbl.hex</code> |
Revision as of 10:38, 11 March 2013
Contents
To flash GRBL to Arduino from Terminal
- Download GRBL
- In the Terminal,
export AVRPATH=/Applications/Arduino.app/Contents/Resources/Java/hardware/tools/avr
export DEVPATH=/dev/tty.usbmodem1411
export GRBLHEX=grbl.hex
- From grbl directory, run
$AVRPATH/bin/avrdude -C$AVRPATH/etc/avrdude.conf -pm328p -carduino -P$DEVPATH -D -Uflash:w:$GRBLHEX
GRBL pinout
https://github.com/grbl/grbl/wiki/Connecting-Grbl
GRBL Settings descriptions
Gcode Commands
My GRBL defaults
$0=28.175 (x, step/mm) $1=28.175 (y, step/mm) $2=250.000 (z, step/mm) $3=10 (step pulse, usec) $4=17780.000 (default feed, mm/min) $5=17780.000 (default seek, mm/min) $6=56 (step port invert mask, int:00111000) $7=25 (step idle delay, msec) $8=500.000 (acceleration, mm/sec^2) $9=0.050 (junction deviation, mm) $10=0.100 (arc, mm/segment) $11=25 (n-arc correction, int) $12=3 (n-decimals, int) $13=0 (report inches, bool) $14=1 (auto start, bool) $15=0 (invert step enable, bool) $16=0 (hard limits, bool) $17=0 (homing cycle, bool) $18=0 (homing dir invert mask, int:00000000) $19=25.000 (homing feed, mm/min) $20=250.000 (homing seek, mm/min) $21=100 (homing debounce, msec) $22=1.000 (homing pull-off, mm)