Week 2 Lab
From Robert-Depot
Set up Breadboard
- Power from arduino to breadboard:
- connect positive and negative power buses on proto board
- run power, "5V" and "GND" from arduino to breadboard.
- verify that this worked (with multimeter, or LED test).
Simple Digital Out
- Set up LED on external board, check that it works
- change Blink program (from Sketchbook->Examples->Digital) to run off of one of the external digital pins
- Pins 0-13 on the "Digital" side of your board. By the power light.
- connect the LED to that pin.
- Does it work?