56
edits
Changes
→Final Project: eMailbox
}
</source>
====Proposed Python Code====
ser.close()
</source>
====Actual Arduino Code: Simple Servo Motor & Light Activation====
Due to my difficulty in executing the Python and Arduino scripts, I decided only to activate the servo motor. This very simple code only provides movement of the servo as well as the blinking of the notification lights.
<source lang="php">
// Sweep
// by BARRAGAN <http://barraganstudio.com>
#include <Servo.h> //include the servo libary
Servo myservo; // create servo object to control a servo
// a maximum of eight servo objects can be created
int pos = 0; // variable to store the servo position
void setup()
{
myservo.attach(9); // attaches the servo on pin 9 to the servo object
}
void loop()
{
for(pos = 0; pos < 180; pos += 1) // goes from 0 degrees to 180 degrees
{ // in steps of 1 degree
myservo.write(pos); // tell servo to go to position in variable ‘pos’
delay(15); // waits 15ms for the servo to reach the position
}
for(pos = 180; pos>=1; pos-=1) // goes from 180 degrees to 0 degrees
{
myservo.write(pos); // tell servo to go to position in variable ‘pos’
delay(15); // waits 15ms for the servo to reach the position
}
}
</source>
===Visualization & Diagram===