5,710
edits
Changes
→Printing a File
==Printing a File==
*See Creatorbot Manual [{{filepath:CreatorBotManual.pdf}} CreatorBotManual.pdf] (thank you Mark from [http://launchlab.ysu.edu LaunchLab])
===Preheat Printer===
Temp -> Preheat -> Preheat PLA 1
===Check Filament Feed===
Visually inspect that filament feeds properly:
#From spool
*through filament sensor (small clip on back for frame)
*through feed motor
*through milky plastic feed tube
*out of extruder hot end.
===Load Filament===
'''Manual Advance Filament'''
Config -> Move -> Extruder -> Extruder #1 '''+25mm'''
=Additional Resources=