Changes

Jump to: navigation, search

Ysu3dp

5 bytes removed, 01:37, 19 October 2016
→‎Slicing a File
3D printable models are generated with slicing software. Slic3r is a good, open source software. We have printer definitions for the CreatorBot to use with slic3r.
'''NOTE: You must first generate a STL file in Rhino (or your preferred 3d modeling software) to import into slic3r''' 
*Open your slicing software, slic3r
*In slic3r, load your printer configuration. '''File->Load Config'''. Select '''Slic3r_creatorbot_config_ABS''' or '''Slic3r_creatorbot_config_PLA''' in the file dialog, depending on what material you are printing.
Retrieved from "http://wiki.roberttwomey.com/Special:MobileDiff/7583"

Navigation menu