5,710
edits
Changes
Created page with "=Preheat Printer= #Turn on the creatorbot. Rocker switch is on the back left side. 400px Temp -> Preheat -> Preheat PLA 1 ===Check Filament Feed==..."
=Preheat Printer=
#Turn on the creatorbot. Rocker switch is on the back left side.
[[File:power_switch.png|400px]]
Temp -> Preheat -> Preheat PLA 1
===Check Filament Feed===
Visually inspect that filament feeds properly:
#from spool
#through filament sensor (small clip on back for frame)
#through feed motor
#through milky plastic feed tube
#out of extruder hot end.
===Load Filament===
'''Manual Advance Filament'''
Config -> Move -> Extruder -> Extruder #1 '''+25mm'''
*See Creatorbot Manual [{{filepath:CreatorBotManual.pdf}} CreatorBotManual.pdf] (thank you Mark from [http://launchlab.ysu.edu LaunchLab])
#Turn on the creatorbot. Rocker switch is on the back left side.
[[File:power_switch.png|400px]]
Temp -> Preheat -> Preheat PLA 1
===Check Filament Feed===
Visually inspect that filament feeds properly:
#from spool
#through filament sensor (small clip on back for frame)
#through feed motor
#through milky plastic feed tube
#out of extruder hot end.
===Load Filament===
'''Manual Advance Filament'''
Config -> Move -> Extruder -> Extruder #1 '''+25mm'''
*See Creatorbot Manual [{{filepath:CreatorBotManual.pdf}} CreatorBotManual.pdf] (thank you Mark from [http://launchlab.ysu.edu LaunchLab])
